Dorit 1: 1 Ratio Dental Handpiece E-Type Internal Irrigation Low Speed

Contra Angle with Fiber Optic

Fiber Optic Handpieces Technical Data

Fiber Optic Contra Angle Handpieces describtion

1. Handpiece head replaced with CA or FG head, which is compatible with KAVO, MK.
2. Fiber optic LED light source, water/air channel isolation. keep perfect performance in instable air pressure and water pressure situation.
3. Made from 303 stainless steel (imported from Japan),durable and dirt free
4. Perfect atomization, cooling uniformity, no droplet out from mouth in use. clean hygiene.
5. Integrate sterilization make it clean simple and convenient.
6. Easy operation, good control, will not make the patient feel pain.
7. Autoclavable at up to 135°(275°F), avoiding cross-infection

About US:

Henan Dorit Biotechnology Co., Ltd is located in the National University Science Park of Hi-Tech Development Zone, Zhengzhou, Henan Province. Henan Dorit specialize in dental treatmen equipment area, main product contains high or low speed dental handpiece, ultrasonic scaler, three-way syringe and Dental LED Curing light. Low speed dental handpiece are mainly used to wear dentures, polished and planted. Divided into straight and bending machine. High Speed dental handpiece mainly used to do treatment and repair more (such as holes, cutting). All our product with CE, TUV, FDA certification, some areas can provide sample service, if you need, pls contact us anytime.

After each patient use , maintenance should be done as follows:

1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate

2. Use a metal needle to clean the spray holes and fumaroles

Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle

3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )

4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom

5. The handpiece with quick connector combination ( first determine the water switch is turned off )

6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )

7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain

8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization

Internal Irrigation Low Speed Handpiece

E Type Low Speed Handpiece

Fiber Optic Low Speed Handpiece

E Type Internal Irrigation Low Speed Handpiece With Fiber Optic Images